|
Re: Figure Stands For Marvel Legends
I've manufactured some basic 3D printed stands, and the major issue is that there's no peghole consistency. Just for modern Hasbro ML, I had to work out 4 different peg diameter/height combinations. That's just for Hasbro ML, and they are still changing them up. I would assume that some of them would translate over to SWB, but who knows.
NECA pegs are bigger than the ones that Hasbro generally uses, so their stands would require modification. The base is also a little overkill if you're just looking for balance, and would limit how closely you can arrange your figures.
The Marauder stands are nice, and are great for 4" figures, but again the peg holes are not necessarily correct for specific figures, and don't offer quite enough balance for 6" figures.
If you want a doll-type stand, I've had the best luck with Obitsu or Variable Action stands. But then you're looking at almost $10 per stand.
|
